Dell Precision 610 - Manual (Page 56)

When you remove an option from its shipping carton, you may find it wrapped in antistatic packing material designed to protect it
from electrostatic damage. Do not remove the packing material until you are ready to install the option.
CAUTION: See " Protecting Against Electrostatic Discharge ".
Removing the Computer Cover
Use the following procedure to remove the computer cover:
1. Turn off your computer and peripherals, and make sure you unplug the computer from its electrical outlet before you remove
the computer cover. Observe the Warning for Your Personal Safety and Protection of Your Equipment described earlier in
this chapter. Also observe the safety instructions at the front of this guide.
2. If you have installed a padlock through the padlock ring on the back panel (see Figure 8-1), remove the padlock.
Figure 8-1. Padlock Installed
3. Remove the cover.
Facing the left side cover, press the release button (located at the bottom-left corner of the front bezel) and lift the bottom of
the cover, allowing it to pivot up toward you (see Figure 8-2).
Disengage the tabs that secure the cover to the top of the chassis, and lift the cover away.
Figure 8-2. Removing the Computer Cover
Replacing the Computer Cover
Use the following procedure to replace the computer cover:
1. Check all cable connections, especially those that might have come loose during your work. Fold cables out of the way so
that they do not catch on the computer cover. Make sure cables are not routed over the drive cage-they will prevent the