Dell Studio Slim D540S (Late 2008) - Manual (Page 16)

8. Align the shoulder screw of the optical drive with the slots in the optical drive bay.
9. Gently slide the optical drive till it snaps in place.
10. Connect the power and data cables to the optical drive.
11. Connect the power and data cables to the system board
12. Replace the front panel (see Replacing the Front Panel ).
13. Replace the computer cover (see Replacing the Computer Cover).
14. Connect your computer and devices to their electrical outlets, and turn them on.
Replacing the Media Card Reader
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Replacing the Computer Cover ).
3. Remove the front panel (see Replacing the Front Panel ).
4. Remove the optical drive (see Replacing the Optical Drive ).
5. Disconnect the FlexBay USB cable and the power cable from the back of the Media Card Reader and from the internal USB connector (F_USB5) on the
system board (see
System Board Components ).
1 optical drive 2 screws (4)
NOTE: If you installed a new drive, see the documentation that came with the drive for instructions on installing any software required for the drive
operation.
1 optical drive 2 spring clamp 3 Media Card Reader