Module cover, Removing the module cover, Replacing the module cover – Dell Inspiron 1318 (Mid 2008) User Manual
Page 2
Back to Contents Page
Module Cover
Dell™ Inspiron™ 1318 Service Manual
Removing the Module Cover
1.
Follow the procedures in
Before You Begin
.
2.
Remove the M2.5 x 5-mm screw and loosen the three captive screws on the cover labeled "M".
3.
Using a flat-blade screwdriver, carefully pry open the module cover.
4.
Lift the module cover away from the computer.
Replacing the Module Cover
1.
Replace the module cover and tighten the three captive screws.
2.
Replace the M2.5 x 5-mm screw.
3.
Slide the battery into the battery bay, until it clicks into place.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions shipped with your computer.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1
M2.5 x 5-mm screw
2
module cover
3
captive screws (3)