Crestron electronic TPMC-8T - Manual (Page 43)

Crestron TPMC-8T Isys i/O™ 8.4” TableTop WiFi Touchpanel
Touch Refresh network list to scan for available access points.
The TPMC-8T is already configured for DHCP. To establish static processing or to
switch between DHCP and static IP, use the General tab of the “Wireless Network
Connection Properties” window (refer to picture on page 37), select Internet
Protocol (TCP/IP) and touch Properties.
Touch Set up a wireless network for a home or small office to start the Wireless
Network Setup Wizard.
The Wireless Network Setup Wizard will create a network with the Network
Authentication value set to Open. If your Wireless Access Point is configured with a
value other than Open, you must set this value manually, using the Wireless
Networks tab of the “Wireless Network Connection Properties” window (refer to
picture on page 38).
To manually configure your Wireless Access Point, perform the following
procedure:
1. In the Preferred Networks section of the window, select your network and
touch Properties to open the “Properties” window for your network.
“Network (your network name) Properties” Window
2. With Data encryption set to WEP, select Open from the Network
Authentication dropdown list.
3. Enter and confirm the Network key.
4. Touch OK.
Operations Guide – DOC. 6567C Isys i/O™ 8.4” TableTop WiFi Touchpanel: TPMC-8T • 39