Cisco 10008 - Manual (Page 22)

22
Cisco 10008 Router Performance Routing Engine 3 Installation
OL-8544-01
Upgrading Software
Step 3 Copy the running configuration to the startup configuration.
Router# copy running-config startup-config
Step 4 Reload the software by entering the reload command.
Router# reload
The system is now using the new Cisco IOS image.
Upgrading Software on Redundant PRE3s
To upgrade software for redundant PRE3s, follow these steps:
Step 1 Verify both PRE3s are up using the show redundancy states command.
Router# show redundancy states
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 0
Redundancy Mode (Operational) = SSO
Redundancy Mode (Configured) = SSO
Redundancy State = SSO
Maintenance Mode = Disabled
Manual swact enabled
Communications = Up
client count = 38
client_notification_TMR = 30000 milliseconds
RF debug mask = 0x0
Step 2 Copy the Cisco IOS image from a TFTP server to Disk0 on the active PRE3.
Router# copy tftp disk0:
Address or name of remote host []? 223.255.254.248
Source filename []? c10008/c10k3-p11-mz
Destination filename [c10k3-p11-mz]?
Accessing tftp://223.255.254.248/c10008/c10k3-p11-mz...
Loading c10008/c10k3-p11-mz from 223.255.254.248(via FastEthernet0/0/0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!...
[OK - 25750196 bytes]
25750196 bytes copied in 50.64 secs (508495 bytes/sec)
Step 3 Copy the Cisco IOS image from a TFTP server to Disk0 on the standby PRE3.
Router# copy tftp stby-disk0
The output is similar to that shown in the previous step.
Step 4 Verify the Cisco IOS image is in the Disk0 directories.
Router# dir disk0:
Directory of disk0:/
1 -rw- 25750196 Mar 4 2000 00:13:24 +00:00 c10k3-p11-mz