Dell Inspiron 2650 - Manual (Page 38)

3. Reinstall the M2.5 x 8-mm screw that secures the video card to the bottom case.
4. Replace the EMI shield .
5. Replace the keyboard .
Palm Rest
1. Remove the keyboard .
2. Remove the display assembly .
3. Remove the EMI shield .
4. Remove the video card .
5. Remove the two M2.5 x 5-mm screws from the top of the palm rest.
6. Turn the computer over and remove the twelve M2.5 x 8-mm screws labeled "circle P."
1 bottom of video card
2 video card connector
3 system board
4 interface connector
5 power-board flex cable
6 memory module
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read " Preparing to Work Inside the Computer " before performing the following procedure.
NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
1 M2.5 x 5-mm screws (2)
2 top of the palm rest