Dell OptiPlex GX1p - Manual (Page 161)

System Setup Program A-1
$ 3 3 ( 1 ' , ; $
6\VWHP6HWXS3URJUDP
This appendix, which applies to all Dell OptiPlex GX1/GX1p Managed PC and
OptiPlex NX1 Net PC computer families, describes the System Setup program,
which is used to change the system configuration information stored in
NVRAM on the system board.
To enter the System Setup program, follow these steps:
1. Turn on (or reboot) the system.
2. Press when the Dell logo screen appears.
If you wait too long and the operating system begins to load into memory, let
the system complete the load operation; then shut down the system and try
again.
NOTE: To ensure an orderly system shutdown, consult the documentation that
accompanied the operating system.