Removing the display bezel – Dell Inspiron 9300 User Manual
Page 25
Removing the Display Bezel
1.
Follow the instructions in "
Before Working Inside Your Computer
."
2.
.
3.
Remove the six rubber screw-covers/display bumpers.
4.
Remove the two screw covers and the four shoulder screws.
5.
Remove the four M2.5 x 5-mm screws at the corners of the bezel.
6.
Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge (A) of
the display assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear
the tab on the side (B) of the lower-right corner.
7.
Repeat
for the lower-left corner of the bezel. Then use your fingers to release the snaps around the rest of the bezel and lift it away from the
display panel.
3 shoulder screws (4)
6 screw covers (2)
CAUTION:
Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To avoid damaging the system board, you must
remove the main battery
before you begin working inside the computer.
NOTICE:
Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel.
1
display back cover
2
tabs