Dell Inspiron 9300 - Manual (Page 23)

4. Turn the computer top-side up.
5. Remove the hinge cover .
6. Open the display all the way (180 degrees) so that it lies flat against the work surface.
7. Use the pull-tab to disconnect the display cable, and then disengage the display cable from the cable channel.
8. Remove the four M2.5 x 5-mm screws (two on each side) that connect the display to the computer base.
9. Lift the display assembly away from the computer.
Replacing the Display Assembly
1. Align the display assembly over the screw holes in the base of the computer.
2. Replace the four M2.5 x 5-mm screws.
1 antenna cables
1 display cable pull-tab
2 M2.5 x 5-mm screws (4)
3 Mini PCI card antenna cables (2)
4 display cable connector on system board
5 display cable in cable channel
1 Mini PCI card antenna cables
NOTE: When removing the display assembly, carefully unthread the Mini PCI card antenna cables through the computer base.