Dell XPS 200 - Manual (Page 77)

Removing and Installing Parts
77
Installing a Hard Drive
1 Unpack the replacement hard drive, and prepare it for installation.
2 Check the documentation for the drive to verify that it is configured for your computer.
NOTE:
If your replacement hard drive does not have the plastic guide bracket attached, remove the
bracket from the old drive by unsnapping it from the drive. Snap the bracket onto the new drive.
3 Connect the power and hard-drive cables to the drive.
4 Check all connectors to be certain that they are properly cabled and firmly seated.
drive
tabs (2)
drive bracket
serial ATA
data cable
power cable