Dell PowerEdge 2650 - Manual (Page 17)

2-Post Rack Installation 1-13
3 Push the tab on the front end of the cable-management arm into a mating latch on
the inner segment of the slide assembly (see Figure 1-7).
The latch clicks when locked.
F i g u r e 1 - 7 . I n s t a l l i n g t h e C a b l e - M a n a g e m e n t A r m
4 Install the system status indicator cable plug into its connector (see Figure 1-8).
5 Open the wire covers on the cable-management arm by lifting the center of the wire
over the top of the embossed round button on the front of the forward part of the arm
and lifting the wire over the top of a similar round button on the back part of the arm.
The wire cover swings open to enable cables to be routed within the arm.
latch on inner segment
of slide assembly
cable-management arm
latch on end of
slide assembly
tab on front end
tab on back end