Dell 1110 Laser Mono Printer - Manual (Page 6)

To power on the printer:
1. Plug one end of the power cord into the power cord connector at the back of the printer and the other end into a properly grounded outlet.
2. Press the power switch to power on the printer.
Printing a Demo Page
Print a demo page to make sure that the printer is operating correctly.
1. Wait approximately 30 seconds for the printer to warm up, then press and hold on the operator panel for 2 seconds to print a demo page.
2. The Demo page shows the printer's current configuration.
CAUTION: The fusing area at the rear part of the inside of your printer becomes hot once the printer is powered on. Be careful not to be burned
when you access this area.
CAUTION: Do not disassemble the printer when it is powered on. If you do, you may receive an electric shock.