Dell XPS 700 Jet Black - Manual (Page 67)

7. Press the release tab (if present) on the system board connector as you grasp the card by its top corners, and then ease the card out of the connector.
8. Install a filler bracket in the empty card-slot opening. If you are replacing the card, see Installing a PCI Express Graphics Card in a Dual Configuration .
9. Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.
10. If present, lower the card-retention device that lays over the installed cards and snap it into place.
11. Replace the computer cover (see Replacing the Computer Cover )
12. Connect your computer and devices to electrical outlets, and then turn them on.
Installing a PCI Express Graphics Card in a Dual Configuration
This section pertains to dual PCI Express graphics card configurations only. For installation of other types of PCI or PCI Express cards, see Installing PCI and
1 release tab 2 card retainer 3 alignment guide
4 fan bracket
NOTE: If the card is full-length, press the release tab on the end of the alignment guides on the fan bracket.
1 PCI Express x16 card 2 securing tab 3 PCI Express x16 card slot
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep
dust and dirt out of your computer.
NOTE: The graphics card bridge (not present in all dual-graphics configurations) is not necessary in a single graphics card configuration.
NOTICE: Before rotating the card retainer back into place, ensure that the tops of all cards and filler brackets are flush with the alignment bar and the
notch in the top of each card or filler bracket fits around the alignment guide.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or
cause damage to the equipment.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer.
NOTE: To upgrade to or downgrade from a dual-graphics configuration, you will need additional parts that can be ordered from Dell (see "Contacting
Dell" in your Owner's Manual).