Dell XPS 700 Jet Black - Manual (Page 112)

2. Remove the computer cover (see Removing the Computer Cover ).
3. Locate the password (PASSWORD) and CMOS (RTCRST) jumpers on the system board (see System Board Components ).
4. Remove the password jumper plug, then place the plug on the CMOS jumper pins and wait approximately 5 seconds.
5. Remove the jumper plug from the CMOS jumper pins, and then reinstall the plug on the password jumper pins to enable the password feature.
6. Close the computer cover (see Replacing the Computer Cover ).
7. Connect your computer and devices to electrical outlets, and then turn them on.
Back to Contents Page
NOTICE: The password jumper plug must be reinstalled on the password jumper pins in order to enable the password feature.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.