Dell Dimension E521 - Manual (Page 68)

68
Removing and Installing Parts
Installing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 61.
2 Press the securing clip at each end of the memory module connector.
3 Align the notch on the bottom of the module with the crossbar in the connector.
1 memory connector farthest
from processor (DIMM_1) 2 securing clips (2) 3 connector
1 cutouts (2) 2 memory module 3 notch
4 crossbar
2
3
1
3
2
1
4
book.book Page 68 Monday, July 23, 2007 3:47 PM