Dell Dimension E521 - Manual (Page 105)

Removing and Installing Parts
105
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the
computer.
8 Connect your computer and devices to electrical outlets, and then turn them on.
9 Enter system setup (see "System Setup" on page 111) and restore the settings you recorded in step 1.
Then go to the Maintenance section and clear the low battery and other errors associated with the
battery replacement in the Event Log.
10 Properly dispose of the old battery.
See the Product Information Guide for battery disposal information.
Replacing the Computer Cover
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
1 Ensure that all cables are connected, and fold cables out of the way.
2 Ensure that no tools or extra parts are left inside the computer.
3 Align the bottom of the cover with the tabs located along the bottom edge of the computer.
4 Using the tabs as leverage, rotate the cover downward and press down to close it.
5 Ensure that the cover is seated correctly before moving it to the upright position.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the
computer.
6 Connect your computer and devices to electrical outlets, and turn them on.
1 computer cover 2 back of computer 3 bottom hinge tabs
1
2
3
book.book Page 105 Monday, July 23, 2007 3:47 PM