Dell POWEREDGE M1000E - Manual (Page 8)

8 FC8PT Pass-Through Module
On On Failure while functioning
2 fast blinks On 2-Gb link rate – normal link up
3 fast blinks On 4-Gb link rate – normal link up
4 fast blinks On 8-Gb link rate – normal link up
Off Slow blink Normal link down or not started
Slow blink Slow blink Off-line for download
Fast blink Slow blink Restricted off-line mode (waiting for restart)
Flashing Slow blink Restricted off-line mode (test active)
Table 1-2. Port Status LED – QLogic
Yellow LED Green LED State
Off Off Power off
On On Power on (before firmware initialization)
Flash Flash Firmware fault
Off On Link up
Off Flash Activity
Flash Off Beacon
Table 1-3. Pass-Through Module Status LEDs
Green LED Yellow/Blue LED State
Off Off The pass-through module is powered off or
an error condition exists
On On (blue) The pass-through module is healthy
On Blinking (yellow) Pass-through module fault
On Off Booting up
On Blinking (blue) Chassis Management Controller identifies
pass-through module
Table 1-1. Port Status LED – Emulex (continued)
Yellow LED Green LED State