Dell POWEREDGE M1000E - Manual (Page 5)

FC8PT Pass-Through Module 5
1. Install the Pass-Through Module
NOTE: Computer equipment contains static-sensitive components that may be
damaged during handling. Static precautions such as grounded wrist straps are
recommended during the installation process.
1 Remove the pin cover from the connector pins at the back of the pass-
through module, as shown in Figure 1-1, Removing the Pin Cover.
Figure 1-1. Removing the Pin Cover
2 Locate an empty module bay in the server.
3 If the selected bay contains an I/O module blank, remove it.
4 Make sure that the latching arm is in the unlatched position, and slide the
pass-through module into the bay until it stops.