Dell Precision M20 - Manual (Page 22)

Back to Contents Page
Center Control Cover
Dell Precision™ M20 Service Manual
Removing the Center Control Cover
Installing the Center Control Cover
Removing the Center Control Cover
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Open the display all the way (180 degrees) so that it lies flat against your work surface.
3. Starting on the right side of the computer, use a plastic scribe to gently pry up the center control cover.
4.
Installing the Center Control Cover
Gently snap the center control cover into place starting from left to right.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1 center control cover 8M659