Dell PowerVault DR4100 User Manual
Page 22

22
DR4100 Best Practice Guide | April 2014
b. Use the following command to verify that bond0 now consists of two 1GB interfaces:
network
–show
Example
administrator@DR1 > network --factory_reset --auto_bonding_speed 1G
WARNING: This will stop all system operation and will reset the network configuration to
factory settings and will require a system reboot. Existing configuration will be lost.
Password required to proceed. Please enter the administrator password:
Resetting network configuration, please wait....
Reboot the system using the command 'system --reboot' to complete the network factory
reset
administrator@DR1 >
system --reboot
Please enter administrator password:
Broadcast message from root (pts/2) (Tue Nov 19 17:43:07 2013):
The system is going down for reboot NOW!
Example
administrator@DR1 > network --show
Automatic bonding speed: 1G
Device : bond0
Enabled : yes
Link : yes
Boot protocol : dhcp
IP Addr : 10.250.242.173
Netmask : 255.255.252.0
Gateway : 10.250.240.1
MAC Addr : BC:30:5B:F3:22:74
MTU : 9000
Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"
Member Interfaces : eth0,eth1
eth0 MAC
: BC:30:5B:F3:22:74
eth0 Max Speed
:1000baseT/Full
eth0 Speed
:1000Mb/s
eth0 Duplex
:Full
eth1 MAC
: BC:30:5B:F3:22:75
eth1 Max Speed
:1000baseT/Full
eth1 Speed
:1000Mb/s
eth1 Duplex
:Full