Dell Latitude 10e ST2E (Early 2013) - Manual (Page 14)

Installing the Speakers
1. Place the right and the left speakers in their slot.
2. Route the speaker cables on the chassis.
3. Tighten the screws to secure the speakers to the chassis.
4. Place the coin-cell battery in its slot and route the cables.
5. Connect the speaker connector cable to its port on the system board.
6. Install the :
a) battery
b) base cover
7. Follow the procedures in After Working Inside Your Computer.
Removing the Docking Board
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) base cover
b) battery
c) speaker
d) front camera
3. Lift up the connector latch and disconnect the docking-board power cable from the connector.
14