Dell Intel PRO Family of Adapters - Manual (Page 4)

Installing the Boot Agent Software Image
Intel server adapters, such as the Intel PRO/1000PT Server Adapter, have a factory-installed, integrated flash ROM device that
has been pre-programmed with a Boot Agent software image. Therefore, no software installation is required.
NOTE: Use BootUtil to enable the flash ROM on some Intel server adapters.
NOTE: For the following adapters, PXE can be enabled through the uEFI environment.
Intel® Ethernet 10G 2P X540-t Adapter
Intel® Ethernet 10G 2P X520 Adapter
Intel® Ethernet 10G 4P X540/I350 rNDC
Intel® Ethernet 10G 2P X520-k bNDC
Intel® Gigabit 4P X540/I350 rNDC
Intel® Gigabit 4P X520/I350 rNDC
Intel® Gigabit 4P I350 bNDC
To do this:
1. Go to System Setup.
2. Choose a port and go to configuration.
3. Specify the boot protocol: PXE, FCoE, iSCSI Primary, or iSCSI Secondary.
NOTE: The following adapters do not support the FCoE boot protocol:
Intel® Gigabit ET Dual Port Server Adapter
Intel® Gigabit ET Quad Port Server Adapter
Intel® Ethernet X520 10GbE Dual Port KX4 Mezz
Intel® Ethernet Server Adapter X520-T2
Intel® Gigabit 4P X520/I350 rNDC
Intel® Gigabit 4P X540/I350 rNDC
Intel® Gigabit 4P I350-t Mezz
Intel® Gigabit 2P I350-t Adapter
Intel® Gigabit 4P I350-t Adapter
Intel® Gigabit 4P I350-t rNDC
Intel® Gigabit 4P I350 bNDC
Intel® Gigabit 2P I350 LOM