Dell Inspiron 1440 (Mid 2009) - Manual (Page 32)

Replacing the Mini-Card
1. Remove the new Mini-Card from its packaging.
2. Insert the Mini-Card at a 45-degree angle into the appropriate system board connector.
3. Press the other end of the Mini-Card down into the slot on the system board and replace the screw that secures the Mini-Card to the system board
connector.
4. Connect the appropriate antenna cables to the Mini-Card. The following table provides the antenna cable color scheme for the Mini-Card supported by
your computer.
5. Secure unused antenna cables in the protective mylar sleeve.
6. Replace the module cover (see Replacing the Module Cover ).
7. Replace the battery (see Replacing the Battery ).
8. Install the drivers and utilities for your computer, as required. For more information, see the Dell Technology Guide.
Back to Contents Page
CAUTION: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.
CAUTION: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system
board, and realign the card.
CAUTION: To avoid damage to the Mini-Card, never place cables under the card.
Connectors on the Mini-Card Antenna Cable Color Scheme
WLAN (2 antenna cables)
Main WLAN (white triangle)
Auxiliary WLAN (black triangle)
white
black
NOTE: If you are installing a communication card from a source other than Dell, you must install the appropriate drivers and utilities. For more generic
driver information, see the Dell Technology Guide.