Display, Display assembly, Removing the display assembly – Dell Inspiron 1440 (Mid 2009) User Manual
Page 18
Back to Contents Page
Display
Dell™ Inspiron™ 1440 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the module cover (see
Removing the Module Cover
).
4.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Remove the optical drive (see
Removing the Optical Drive
).
7.
Remove the two screws from the computer base.
8.
Remove the center control cover (see
Removing the Center Control Cover
).
9.
Remove the keyboard (see
Removing the Keyboard
).
10.
Remove the power button board (see
Removing the Power Button Board
).
11.
Remove the palm rest (see
Removing the Palm Rest
).
12.
Disconnect the camera cable from the system board connector.
13.
Make note of the Mini-Card antenna cables, camera cable, and the display cable routing and remove the cables from their routing guides.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.