Cecilware GB-IT - Manual (Page 5)

5
ADJUSTMENTS - ILL. B
WATER FLOW RATE
The Dispense Valves are factory adjusted fo r a maximum Flow Rate of 1 to 1.3 oz./sec.
[Approximate settings: 0.85 to 1 oz./sec for SOUP; 1.3 oz./sec. for COFFEE and CAPPUCCINO]
Exceeding this Flow Rate will cause the Mixing Chamber to overflow.
Note: To access the Water Dispense Valves, open door and remove Hoppers.
TO ADJUST WATER FLOW RATE:
1. Open door and remove hoppers. Locate Dispense Valve behind hoppers, mounted on tank.
2. Locate adjustment screw on Dispense Valve.
3. Using Allen Key or flat screwdriver rotate, 1/4 turn at a time,
CLOCKWISE to decrease water flow, or COUNTERCLOCKWISE
to increase water flow.
4. Check water flow output, after each 1/4 turn.
HOPPERS AND AUGERS
CD130 NYLON AUGER [22.5mm%%c X 17mmPT]
W/O-RING CD139
CD101 WIRE AUGER [22.5mm%%c X 17mmPT]
CAPPUCCINO/FAST FLOW & SOUP
CD149 WIRE AUGER {22.5mm%%c X 24.8mmPT]
HOT CHOCOLATE & THICK SOUP
CD74A WIRE AUGER {17mm%%c X 12mmPT]
DRY COFFEE/FAST FLOW
CD153 WIRE AUGER [17mm%%c X 9.15mmPT]
DRY COFFEE & INSTANT ESPRESSO
A. When using NYLON AUGERS:
Adjust Water Flow Rate so that the
water level reaches almost at the top
in the Mixing Chamber, as shown.
B. When using WIRE AUGERS:
Adjust Water Flow Rate so that the
water level reaches half way up
in the Mixing Chamber, as shown.
CD76A
AUGERS:
CD90A
PRODUCT
GUIDE
CD70A
AUGER GEAR
CD117 [w/NYLON AUGER CD130]
CD117 [w/WIRE AUGER CD101 & CD149]
CD97A [w/WIRE AUGER CD74A & CD153]
CORRECT WATER
LEVEL FOR MAX
FLOW RATE WHEN
USING WIRE AUGER
CORRECT WATER
LEVEL FOR MAX
FLOW RATE WHEN
USING NYLON
AUGER
RECTANGULAR RIB
DISPENSE CAP
CD61A
DISPENSE CAP
CD61A
CD115
SPLASH GUARD
MIXING CHAMBER CD145
FAST FLOW [COLD]
MIXING CHAMBER CD137
FAST FLOW [HOT]
MIXING CHAMBER CD62A
SOUP UNITS
TRIANGULAR
RIB
OR