Canon LV-7275 EN User Manual
Page 80
7
6. Mantenance
5. Connect the supplied power cord, turn on the Main Power switch and turn on the projector.
6. Finally, select the menu
→ [Reset] → [Lamp counter] to reset the lamp usage hours.
NOTE: When you continue to use the projector for another 100 hours after the lamp has reached the end of its life, the projector
cannot turn on and the menu is not displayed.
If this happens, press the INFO button on the remote control for 10 seconds to reset the lamp clock back to zero.
When the lamp time clock is reset to zero, the LAMP indicator goes out.
4. Reattach the lamp cover.
(1) Insert three tabs into three grooves.
(2) Push down both ends of the lamp cover until you feel click.
3. Install a new lamp.
(1) Insert a new lamp until the lamp is plugged into the socket.
CAUTION
Do not use a lamp other than the replacement lamp LV-LP31.
Order this from your dealer.
(2) Push the top center of the lamp to secure it.
(3) Secure it in place with the two screws.
• Be sure to tighten the screws.