Canon LV-7275 EN - Manual (Page 38)

9
. Projectng an Image (Basc Operaton)
1
2
4
3
adjustable tilt foot adjustable tilt
foot lever
Adjusting the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjustment
as it can become heated while the projector is turned on and during
its cool down period after it is turned off.
2. Push straight up and hold the Adjustable Tilt Foot Lever on the
front of the projector to extend the adjustable tilt foot.
3. Lower the front of the projector to the desired height.
4. Release the Adjustable Tilt Foot Lever to lock the Adjustable tilt
foot.
the tilt foot can be extended up to 1.8 inch/45 mm.
there is approximately 10 degrees (up) of adjustment for the front
of the projector.
rotate the rear foot to the desired height in order to square the im-
age on the projection surface.
CAUTION:
• Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall
or ceiling) the projector can cause damage to the projector.
Adjustng the left and rght tlt of an mage [Rear foot]
1. Remove the spacer (black rubber) from the rear foot.
a spacer is provided for leveling the projector. Keep the spacer for
future use.
2. Rotate the rear foot.
the rear foot can be extended up to 0.4 inch/10 mm. rotating the
rear foot allows the projector to be placed horizontally.
NOTE:
• Do not extend the rear foot beyond its height limit (0.4 inch/10 mm). Doing
so may cause the rear foot to come out of the projector.
• After using the projector, attach the spacer to the rear foot.
spacer
(black rubber)
rear foot
Up Down