beautypg.com

Dodge 2015 Challenger - User Guide User Manual

Page 177

background image

5. Remove the Speed Limit sticker from the instrument panel after the tire has been

repaired.

6. Replace the Sealant Bottle (1) and Sealant Hose (6) assembly at your authorized

dealer as soon as possible. Refer to “(F) Sealant Bottle and Hose Replacement.”

NOTE:
• If the tire becomes over-inflated, push the Deflation Button to reduce the tire pressure

to the recommended inflation pressure before continuing.

• When having the tire serviced, advise the authorized dealer or service center that the

tire has been sealed using the Tire Service Kit.

(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in the recessed area under the sealant

bottle.

3. Push the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Remove the

bottle and dispose of it accordingly.

4. Clean any remaining sealant from the Tire Service Kit housing.
5. Position the new Sealant Bottle (1) in the housing so that the Sealant Hose (6) aligns

with the hose slot in the front of the housing. Push the bottle into the housing. An
audible click will be heard indicating the bottle is locked into place.

6. Verify that the cap is installed on the fitting at the end of the Sealant Hose (6) and

return the hose to its storage area (located on the bottom of the air pump).

7. Return the Tire Service Kit to its storage location in the vehicle.

NOTE:
• The metal end fitting from Power Plug (8) may get hot after use, so it should be handled

carefully.

• Failure to reinstall the cap on the fitting at the end of the Sealant Hose (6) can result

in sealant contacting your skin, clothing, and the vehicle’s interior. It can also result in
sealant contacting internal Tire Service Kit components which may cause permanent
damage to the kit.

W H AT T O D O I N E M E R G E N C I E S

175