Braking distance, Current g-force, Peak g-force – Dodge 2015 Challenger - User Guide User Manual
Page 154: Lap timer, S r t
Braking Distance
When selected, this screen displays the vehicle's braking distance and the speed at which
the brake pedal was depressed.
• This feature will only function when applying the brakes at speeds above 30 mph
(48 km/h).
• Engaging the parking brake will disable this feature.
• The word “READY” will display when conditions are met for the event to begin.
• The distance and speed measurements display while the event is taking place.
• The distance measurement will be aborted if the brake pedal is released before the
vehicle comes to a complete stop.
• The distance and speed measurements will continue to display until the
OK button is
pushed.
• Pushing the
OK button will clear the current run and prepare the cluster to record a new
run.
Current G-Force
• When selected, this screen displays the current G-Force (lateral and longitudinal) along
with a friction circle that displays the directions of the forces.
Peak G-Force
When selected, this screen displays all four G-Force values (two lateral and two longitu-
dinal).
• When a force greater than zero is measured, the display will update the value as it
climbs. As the G-Force falls, the peak forces will continue to display.
• Pushing the
OK button will clear the peak force values.
Lap Timer
When selected the Lap Timer page will show the timer always at 0:00.00 with the previous
Best and Last time data (unless the driver has cleared it via hold to Reset).
• Pushing OK will start “current” timer from 0:00.0.
• When OK is pushed the times are updated accordingly.
• As soon as the driver exits the Lap Timer pages the “current” timer will stop and the
time will be reset to 0:00.00.
• If the driver stays on the Lap Timer pages the “current” timer will reset to 0:00.0 when
ignition is placed in the off position, or ignition placed in the ON position (or will roll
over at 59:59.99 if ever possible).
• Each time the driver pushes OK for a Lap that current time populates the Last time and
also populates the 1st (top) space on the Timer History page the current time resets to
0:00.0 at every push of the OK button.
• The timer will stop when the driver navigates away from this page.
S R T
152