Dodge 2013 Dart - Owner Manual User Manual

Page 503

• Always start the engine before turning ON the TIRE-

FIT kit.

NOTE:

Manual transmission vehicles must have the

parking brake engaged and the shift lever in NEUTRAL.

• After pressing the Power Button (4), the sealant (white

fluid) will flow from the Sealant Bottle (1) through the
Sealant Hose (6) and into the tire.

NOTE:

Sealant may leak out through the puncture in

the tire.

If the sealant (white fluid) does not flow

within 0 –

10 seconds through the Sealant Hose (6):

1. Press the Power Button (4) to turn Off the TIREFIT kit.
Disconnect the Sealant Hose (6) from the valve stem.
Make sure the valve stem is free of debris. Reconnect the
Sealant Hose (6) to the valve stem. Check that the Mode
Select Knob (5) is in the Sealant Mode position and not
Air Mode. Press the Power Button (4) to turn On the
TIREFIT kit.

2. Connect the Power Plug (8) to a different 12 Volt
power outlet in your vehicle or another vehicle, if avail-
able. Make sure the engine is running before turning ON
the TIREFIT kit.

3. The Sealant Bottle (1) may be empty due to previous
use. Call for assistance.

WHAT TO DO IN EMERGENCIES

501