beautypg.com

Canadian/gate operator programming – Dodge 2013 Dart - Owner Manual User Manual

Page 256

background image

4. Continue to hold both buttons and observe the indi-
cator light. The Homelink

௡ indicator will flash slowly

and then rapidly after Homelink

௡ has received the fre-

quency signal from the hand-held transmitter. Release
both buttons after the indicator light changes from slow
to rapid.

5. Press and hold the programmed HomeLink

௡ button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device
should activate when the HomeLink

௡ button is

pressed.

• To program the two remaining HomeLink௡ buttons,

repeat each step for each remaining button. DO
NOT erase the channels.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button until

the indicator light begins to flash after 20 seconds. Do not
release the button.

3. Without releasing the button proceed with “Program-
ming A Non-Rolling Code” Step 2 and follow all remain-
ing steps.

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States
that require the transmitter signals to “time-out” after
several seconds of transmission.

254

UNDERSTANDING THE FEATURES OF YOUR VEHICLE