Enabling and disabling parksenseĥ, Service the parksenseĥ rear park assist system, Enabling and disabling parksense – Dodge 2013 Dart - Owner Manual User Manual
Page 242: Service the parksense rear park assist, System
Enabling And Disabling ParkSense
ா
ParkSense
can be enabled and disabled using the
Uconnect
System. The available choices are: Off, Sound
Only, or Sound and Display. Refer to “Uconnect
Set-
tings” in “Understanding Your Instrument Panel” for
further information.
When the ParkSense
soft-key is pressed to disable the
system, the EVIC will display the “PARK ASSIST SYS-
TEM OFF” message for approximately five seconds.
Refer to “Electronic Vehicle Information Center (EVIC)”
in “Understanding Your Instrument Panel” for further
information. When the shift lever is moved to REVERSE
and the system is disabled, the EVIC will display the
“PARK ASSIST SYSTEM OFF” message for approxi-
mately five seconds.
Service The ParkSense
ா
Rear Park Assist System
When the ParkSense
Rear Park Assist system is mal-
functioning, the Electronic Vehicle Information Center
(EVIC) will actuate a single chime, once per ignition
cycle, and it will display the “WIPE OFF REAR PARK
ASSIST SENSORS”, “SERVICE PARK ASSIST SENSORS”
or “SERVICE PARK ASSIST SYSTEM” message. Refer to
“Electronic Vehicle Information Center (EVIC)” in “Un-
derstanding Your Instrument Panel” for further informa-
tion. When the shift lever is moved to REVERSE and the
system has detected a fault condition, the EVIC will
display the “WIPE OFF REAR PARK ASSIST SENSORS”,
“SERVICE PARK ASSIST SENSORS” or the “SERVICE
PARK ASSIST SYSTEM” message for as long as the
vehicle is in REVERSE. Under this condition, ParkSense
will not operate.
240
UNDERSTANDING THE FEATURES OF YOUR VEHICLE