beautypg.com

Parksenseĥ sensors, Parksenseĥ warning display, Parksense௡ sensors – Dodge 2013 Dart - Owner Manual User Manual

Page 234: Parksense௡ warning display

background image

ParkSense

௡ will retain the last system state (enabled or

disabled) from the last ignition cycle when the ignition is
changed to the ON/RUN position.

ParkSense

௡ can be active only when the shift lever is in

REVERSE. If ParkSense

௡ is enabled at this shift lever

position, the system will remain active until the vehicle
speed is increased to approximately 7 mph (11 km/h) or
above. The system will become active again if the vehicle
speed is decreased to speeds less than approximately
6 mph (9 km/h).

ParkSense

Sensors

The four ParkSense

௡ sensors, located in the rear fascia/

bumper, monitor the area behind the vehicle that is
within the sensors’ field of view. The sensors can detect
obstacles from approximately 12 in (30 cm) up to 79 in
(200 cm) from the rear fascia/bumper in the horizontal
direction, depending on the location, type and orienta-
tion of the obstacle.

ParkSense

Warning Display

The ParkSense

௡ Warning screen will only be displayed if

Sound and Display is selected from the Uconnect

௡ Sys-

tem. Refer to “Uconnect

௡ Settings” in “Understanding

Your Instrument Panel” for further information.

The ParkSense

௡ Warning screen is located within the

Electronic Vehicle Information Center (EVIC). It provides
visual warnings to indicate the distance between the rear
fascia/bumper and the detected obstacle. Refer to “Elec-
tronic Vehicle Information Center (EVIC)/Settings” in
Understanding Your Instrument Panel” for further
information.

232

UNDERSTANDING THE FEATURES OF YOUR VEHICLE