Dodge 2013 Dart - Owner Manual - Manual (Page 121)

Voice Command Button
When you press the Voice Command
button you will hear a BEEP. The beep is your
signal to give a command.
The Uconnect ௡ Phone can be used with any Hands-Free
Profile certified Bluetooth
௡ mobile phone. See the
Uconnect ௡ website for supported phones. Refer to your
mobile service provider or the phone manufacturer for
details.
The Uconnect
௡ Phone is fully integrated with the vehi-
cle’s audio system. The volume of the Uconnect ௡ Phone
can be adjusted either from the radio volume control
knob or from the steering wheel radio control (right
switch), if so equipped.
The radio display will be used for visual prompts from
the Uconnect
௡ Phone such as “Phone” or caller ID.
Operation
Voice commands can be used to operate the Uconnect ௡
Phone and to navigate through the Uconnect
௡ Phone
menu structure. Voice commands are required after most
Uconnect
௡ Phone prompts. You will be prompted for a
specific command and then guided through the available
options.
• Prior to giving a voice command, one must wait for
the beep.
• For certain operations, compound commands can be
used. For example, instead of saying “Setup”, “Device
Pairing” and then “Pair a Device”, the following
compound command can be said: “Setup”, “Device
Pairing” and “Pair a Bluetooth
௡ Device”.
• For each feature explanation in this section, only the
compound form of the voice command is given. You
can also break the commands into parts and say each
part of the command when you are asked for it. For
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119