beautypg.com

Before you begin programming homelinkĥ, Programming a rolling code, Before you begin programming – Dodge 2013 Dart - Owner Manual User Manual

Page 253: Homelink

background image

Before You Begin Programming HomeLink

Be sure that your vehicle is parked outside of the garage
before you begin programming.

For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink

system.

Erase all channels before you begin programming. To
erase the channels place the ignition in the ON/RUN
position and press and hold the two outside HomeLink

buttons (I and III) for up 20 seconds or until the red
indicator flashes.

NOTE:

• Erasing all channels should only be performed when

programming HomeLink

௡ for the first time. Do not

erase channels when programming additional buttons.

• If you have any problems, or require assistance, please

call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.

Programming A Rolling Code

For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used to
open and close the door. The name and color of the
button may vary by manufacturer.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

251