Clarion AX430 - Manual (Page 7)

AX430
9
• Z-ENHANCER 1: bass emphasized
• Z-ENHANCER 2: treble emphasized
• Z-ENHANCER 3: bass and treble emphasized
• Z-EHCR OFF: no sound effect
Loudness Function
Press the [A-M] button for at least 1 second to
turn the loudness function on and off.
Switching the Display
Press the [DISP] button to enter the clock dis-
play mode.
Operation mode display
➜ Clock display ➜ Op-
eration mode display
Setting the Clock
1) Press the [DISP] button to enter the clock dis-
play mode.
2) Press the [DISP] button for 1 second or longer.
This enables clock editing.
* The editable fields will be indicated by flash.
3) To move between the hour and minute fields,
use the [ ] Left (hour) and [ ] Right
(minute) buttons.
4) To confirm the clock setting, press the [DISP]
button.
Notes:
• If you select another operation mode before com-
pleting the above procedure, the clock setting
operation will be canceled.
• Removing the battery for a check or repair causes
the clock to be reset. Set the clock again in such
a case.
Basic Operation
Radio Operation
FM Reception
For enhanced FM performance the
tuner includes signal actuated stereo control and
Multipath noise reduction circuits.
Listening to the Radio
1) Press the [FNC] button and select the radio
mode. The radio turns on.
2) To tune in a preset station, first press the [BND]
button and select FM1, FM2, FM3 or AM.
The band changes as follows each time the
[BND] button is pressed:
FM1
➜ FM2 ➜ FM3 ➜ AM ➜ FM1
3) Use the [DIRECT] buttons to select the de-
sired station.
Mute
Use this function to turn off the sound immedi-
ately.
Press the [ s] button. The sound turns off and
“MUTE” appears on the display. Press the [ s]
button again to cancel the mute mode.
Seek Tuning
1) Press the [BND] button and select the desired
band.
2) Press the [ ] or [ ] button. Seek tuning
automatically stops when a station is found.
Manual Tuning
1) Press the [BND] button and select the desired
band.
2) Press the [BND] button again for more than 1
second. “MANU” lights in the display and the
manual tuning mode is set.
3) Use the [ ] and [ ] buttons to tune in the
desired frequency.
Presetting Stations
A total of 24 stations can be preset, 6 each for
the FM1, FM2, FM3 and AM bands.
Note:
• When a station is preset, the station previously
stored in the memory at that position is cleared.