Clarion AX430 - Manual (Page 6)

8
AX430
7. OPERATION
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “2. CONTROLS” on page 3 (unfold).
Basic Operation
CAUTION
Adjusting the Treble
1) Press [A-M] button and select “TREB”.
2) Turning the [ROTARY] knob clockwise empha-
sizes the treble; turning it counterclockwise at-
tenuates the treble.
* The factory default setting is “0”. (Adjustment
range: –6 to +6)
3) When the adjustment is complete, press [A-M]
button several times until the function mode is
reached.
Adjusting the Balance
1) Press [A-M] button and select “BAL”.
2) Turning the [ROTARY] knob clockwise empha-
sizes the sound from the right speaker; turn-
ing it counterclockwise emphasizes the sound
from the left speaker.
* The factory default setting is “0”. (Adjustment
range: L9 to R9)
3) When the adjustment is complete, press [A-M]
button several times until the function mode is
reached.
Adjusting the Fader
1) Press [A-M] button and select “FAD”.
2) Turning the [ROTARY] knob clockwise empha-
sizes the sound from the front speakers; turn-
ing it counterclockwise emphasizes the sound
from the rear speakers.
* The factory default setting is “0”. (Adjustment
range: F9 to R9)
3) When the adjustment is complete, press [A-M]
button several times until the function mode is
reached.
Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you pre-
fer.
* The factory default setting is “Z-EHCR OFF”.
Each time you press [Z-EHCR] button, the tone
effect changes in the following order.
“Z-ENHANCER 1”
➜ “Z-ENHANCER 2” ➜
“Z-ENHANCER 3”
➜ “Z-EHCR OFF” ➜
“Z-ENHANCER 1”...
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
1) Press the [FNC] button.
* To turn the power off, press the [FNC] button
for at least 1 second.
2) Press the [FNC] button to select the opera-
tion mode. The mode switches as follows each
time the [FNC] button is pressed:
Radio
➜ Tape ➜ CD changer ➜ Radio
* If a component is not connected, that opera-
tion mode cannot be selected.
* “CASS” appears when no tape is loaded in
the source unit, and “DISC” appears when
no disc is loaded in the CD changer.
3) Turning the [ROTARY] knob clockwise in-
creases the volume; turning it counterclock-
wise decreases the volume.
* The volume level is from 0 (minimum) to 33
(maximum).
Audio Mode Adjustments
Press the [A-M] button to select the adjustment
mode. The mode switches as follows each time
the [A-M] button is pressed:
BASS
➜ TREB ➜ BAL ➜ FAD ➜ Previous mode
Adjusting the Bass
1) Press [A-M] button and select “BASS”.
2) Turning the [ROTARY] knob clockwise empha-
sizes the bass; turning it counterclockwise at-
tenuates the bass.
* The factory default setting is “0”. (Adjustment
range: –6 to +6)
3) When the adjustment is complete, press[A-M]
button several times until the function mode is
reached.