Canon SX7 MARKII - Manual (Page 2)

2
Quick Reference – How to start projection
Computer
1.
Install the projector. P32-33
z
Install the projector at the desired distance from the screen.
2.
Connect the projector. P36-39
z Connect the projector and the computer with a cable.
3.
Turn on the projector. P40-41
z
Connect the power cord and turn on the projector.
z
Adjust the height of the projecting image (P43).
z
Select a display language when turning on the projector for the first time (P41).
4.
Press the button twice. P46-47
z
Adjust the focus of the screen.
5.
Set up the computer. P44-45
z Turn on the computer and set the resolution.
6.
Select the input signal by pressing the button. P48-50
z Select an appropriate input signal in accord with the signal from the computer.
7.
Press the button twice again. P46-47
z
Adjust the input signal, focusing, keystone distortion, etc. automatically with the
auto setup function.
8.
Press the button. P54
z
Optimize the input signal with the auto PC function (Skip this step if the projector
is projecting an image properly.)
9.
Select the image mode with the button. P55-56
z Select an appropriate image mode for projection.
z Specify the aspect ratio or display area in the [Aspect] menu as required (P57,
90).
10.
Start the presentation. P78-83
z
Set the useful functions available during the presentation from the remote control.
Turn off the projector P60-61
z
Turn off the projector and unplug the power cord.
Finishing the projection...