Canon SX7 MARKII - Manual (Page 15)

15
S
A
FE
TY INSTRUC
TION
S
When placing the projector on a castered stand or table, be sure to lock the
casters.
z Failure to do so may cause the projector to move or topple, resulting in an
injury.
Position the projector in a horizontal position. Incorrect installation may cause
troubles and accidents.
z Do not tilt the projector more than 20
degrees above and below the horizontal.
z When you want to use your projector
pointing up or down, make sure to place
the projector straight up or down.
Do Not Use in the Following Environments
z Do not place the projector on an unstable or slanted surface. The projector
may fall causing a personal injury.
z Do not place it in an oily, smoky, or damp location (e.g., near a cooking table
or a humidifier). It may cause a fire or an electric shock.
z Place the projector with a minimum distance of 1 m (3.3') from its left, right,
rear, and top panels to the neighboring object such as a wall. Otherwise, it
may damage the projector due to bad exhaust ventilation.
z Do not put anything near the exhaust vent that may deform or deteriorate
due to heat.
z Do not install the projector in a humid or dusty location or a position where
there is a lot of oily or cigarette smoke. Optical parts such as a lens and
mirror may be stained, resulting in poor picture quality.
z Do not place it near an exhaust outlet of air-conditioning equipment.
Otherwise, it may be damaged.
If the projector is carried from a cold place to a warm place or the room
temperature is raised rapidly, condensation may form on the lens and mirror due
to the moisture in the atmosphere, resulting in a blurred picture. Wait until
condensation evaporates and normal picture is shown.
Do not use the projector in a place subject to either very high or very low
temperatures. Doing so may cause malfunction. The ranges of the operating
and storage temperatures are as shown below:
Operating temperature: +5°C to +35°C (Humidity: 85% or below)
Storage temperature: -10°C to +60°C (Humidity: 90% or below)
Using the Projector at 2300 Meters or More Above Sea Level
z If you use the projector at 2300 meters or more above sea level, the special
configuration is required to cool down the projector properly. Contact your
dealer.
Caution
20°
20°