Erasing homelink buttons, Reprogramming a single homelink button, Driver controls – FORD 2010 Explorer v.2 User Manual
Page 139
Erasing HomeLink
ா buttons
Console mount
Visor mount
To erase the three programmed buttons (individual buttons cannot be
erased):
• Press and hold the two outer HomeLink buttons until the indicator
light begins to flash-after 20 seconds. Release both buttons. Do not
hold for longer that 30 seconds.
HomeLink
is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.
Reprogramming a single HomeLink
ா button
To program a device to HomeLink
using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
button, follow Step 1 in the Programming
section.
For questions or comments, contact HomeLink
at www.homelink.com
or 1–800–355–3515.
Driver Controls
139
2010 Explorer (exp)
Owners Guide, 2nd Printing
USA (fus)