beautypg.com

Driver controls – FORD 2010 Explorer v.2 User Manual

Page 136

background image

Console mount

Visor mount

1. Position the end of your hand-held transmitter 1–3 inches (2–8 cm)
away from the HomeLink

௡ button you wish to program while keeping the

indicator light in view.

2. Simultaneously press and hold both the chosen HomeLink

௡ and

hand-held transmitter buttons until the HomeLink

௡ indicator light

changes from a slow to a rapidly blinking light. Now you may release
both the HomeLink

௡ and hand-held transmitter buttons.

Note: Some entry gates and garage door openers may require you to
replace Step 2 with procedures noted in the Gate Operator and
Canadian Programming
section for Canadian residents.

3. Firmly press and hold for five seconds and release the
programmed HomeLink

௡ button up to two separate times to activate the

door. If the door does not activate, press and hold the just-trained
HomeLink

௡ button and observe the indicator light.

• If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink

௡ button is pressed

and released.

• If the indicator light blinks rapidly for two seconds and then turns
to a constant light continue with “Programming” Steps 4 through
6
to complete programming of a rolling code equipped device (most
commonly a garage door opener).

Driver Controls

136

2010 Explorer (exp)
Owners Guide, 2nd Printing
USA
(fus)

This manual is related to the following products: