beautypg.com

Operating the homelink wireless control system, Driver controls – FORD 2010 Explorer v.2 User Manual

Page 138

background image

After completing Step 1 outlined in the Programming section, replace
Step 2 with the following:

Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.

• Continue to press and hold the HomeLink௡ button (note Step 2 in the

Programming section) while you press and release —

every two

seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with Step 3 in the Programming section.

Operating the HomeLink

Wireless Control System

Console mount

Visor mount

To operate, simply press and release the appropriate HomeLink

௡ button.

Activation will now occur for the trained product (garage door, gate
operator, security system, entry door lock, or home or office lighting
etc.). For convenience, the hand-held transmitter of the device may also
be used at any time. In the event that there are still programming
difficulties, contact HomeLink

௡ at www.homelink.com or

1–800–355–3515.

Driver Controls

138

2010 Explorer (exp)
Owners Guide, 2nd Printing
USA
(fus)

This manual is related to the following products: