beautypg.com

Instrument cluster – FORD 2010 Expedition v.3 User Manual

Page 23

background image

5. Press and hold the SELECT/RESET stem until the message center
displays CIRCLE SLOWLY TO CALIBRATE. This step may require up to
five circles to complete the calibration.

NOTE: If the SELECT/RESET stem is pressed during the calibration or
three minutes has elapsed since the beginning of the calibration without
driving the vehicle, the message center reverts back to normal operation
and the CAL will display until a successful calibration is carried out.

6. Slowly drive the vehicle in a circle less than 3 mph (5 km/h ) until the
CIRCLE SLOWLY TO CALIBRATE message changes to CALIBRATION
COMPLETED.

Setup menu (vehicle customization and vehicle system check)

HOLD RESET FOR SETUP MENU

Press and hold the SELECT/RESET stem to get into the setup menu
sequence for the following displays:

Note: When returning to the SETUP menu and a non-English language
has been selected, HOLD RESET FOR ENGLISH will be displayed to
change back to English. Press and hold the SELECT/RESET stem to
change back to English.

HOLD RESET FOR SYSTEM CHECK

Press and hold the SELECT/RESET stem to start the system check when
HOLD RESET FOR SYSTEM CHECK is displayed in the message center.
For each of the monitored systems, the message center will indicate
either an ok message or a warning message for two seconds. Pressing the
SELECT/RESET stem cycles the message center through each of the
systems being monitored.

Note: Some systems show a message only if a condition is present.

1. OIL LIFE

2. CHARGING SYSTEM

3. WASHER FLUID LEVEL

4. DOOR/LIFTGATE/GLASS AJAR

5. BRAKE SYSTEM

6. TIRE PRESSURE

7. FUEL LEVEL (will only display if 50 miles or less to empty)

8. MYKEY DISTANCE (if programmed)

9. MYKEY(S) PROGRAMMED

10. ADMIN KEYS PROGRAMMED

Instrument Cluster

23

2010 Expedition (exd)
Owners Guide, 3rd Printing
USA
(fus)

This manual is related to the following products: