beautypg.com

Driver controls – FORD 2010 Expedition v.3 User Manual

Page 145

background image

Note: Your vehicle may require the ignition switch to be turned to the
accessory position for programming and/or operation of the HomeLink

௡.

It is also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink

௡ for quicker

training and accurate transmission of the radio-frequency signal.

1. Position the end of your
hand-held transmitter 1–3 inches
(2–8 cm) away from the HomeLink

button you wish to program (located
on your visor) while keeping the
indicator light in view.

2. Simultaneously press and hold
both the chosen HomeLink

௡ and

hand-held transmitter buttons until the HomeLink

௡ indicator light

changes from a slow to a rapidly blinking light. Now you may release
both the HomeLink

௡ and hand-held transmitter buttons.

Note: Some entry gates and garage door openers may require you to
replace Step 2 with procedures noted in the Gate Operator and
Canadian Programming
in this section for Canadian residents.

3. Firmly press and hold for five seconds and release the
programmed HomeLink

௡ button up to two separate times to activate the

door. If the door does not activate, press and hold the just-trained
HomeLink

௡ button and observe the indicator light.

• If the indicator light stays on constantly, programming is complete

and your device should activate when the HomeLink

௡ button is pressed

and released.

• If the indicator light blinks rapidly for two seconds and then turns

to a constant light continue with “Programming” Steps 4 through
6
to complete programming of a rolling code equipped device (most
commonly a garage door opener).

4. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).

5. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)

Note: There are 30 seconds in which to initiate Step 6.

6. Return to the vehicle and firmly press, hold for two seconds and
release
the programmed HomeLink

௡ button. Repeat the

press/hold/release sequence again and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.

Driver Controls

145

2010 Expedition (exd)
Owners Guide, 3rd Printing
USA
(fus)

This manual is related to the following products: