Erasing personal code, Anti-scan feature, Locks and security – FORD 2011 Explorer v.3 User Manual
Page 150
Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory set code will work even if you have set your own personal
code.
Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds, press the 1
• 2 on the keypad and release.
3. Press and hold the 1
• 2 for two seconds. This must be done within
five seconds of completing Step 2.
All personal codes are now erased and only the factory set 5–digit code
will work.
Anti-scan feature
If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the
control on the transmitter.
• the ignition is turned on.
• unlocking the vehicle using intelligent access (if equipped).
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate. Note: If the two-stage unlocking
feature is disabled, all doors will unlock; for more information regarding
two-stage unlocking, refer to the Unlocking the doors/Two stage unlock
section earlier in this chapter.
To unlock all doors, enter the factory set code or your personal code,
then press the 3
• 4 control within five seconds.
To lock all doors, press and hold the 7
• 8 and the 9 • 0 at the same
time (with the driver’s door closed). You do not need to enter the
keypad code first.
To enable/disable autolock/autounlock, refer to Autolock feature or
Autounlock feature earlier in this chapter.
Locks and Security
150
2011 Explorer (exp)
Owners Guide, 4th Printing
USA (fus)