beautypg.com

Driver controls – FORD 2011 Explorer v.3 User Manual

Page 117

background image

1. To program units with fixed code DIP switches, you will need the
garage door hand-held transmitter, paper and a pen or pencil.
2. Open the battery cover and record the switch settings from left to
right for all 8 to 12 switches. Use the figure below:
When a switch is in the up, on, or + position, circle “L.”
When a switch is in the middle, neutral, or 0 position, circle “M.”
When a switch is in the down, off, or – position, circle “R.”

Switch
position

1

2

3

4

5

6

7

8

9

10

11

12

Up, on
or +

L

L

L

L

L

L

L

L

L

L

L

L

Middle,
neutral
or 0

M

M

M

M

M

M

M

M

M

M

M

M

Down,
off or –

R

R

R

R

R

R

R

R

R

R

R

R

L=left; M=middle; R=right

3. To input these positions into the
Car2U

௡ system, simultaneously

press all three Car2U

௡ system

buttons for a few seconds and then
release to put the device into
programming mode. The indicator
lights will blink slowly. Within
2.5 minutes enter your
corresponding DIP switch settings
from left to right into your Car2U

௡ system by pressing and releasing the

buttons corresponding to the settings you circled.
4. After inputting switch settings, simultaneously press and release all
three Car2U

௡ system buttons. The indicator lights will turn on.

Driver Controls

117

2011 Explorer (exp)
Owners Guide, 4th Printing
USA
(fus)

This manual is related to the following products: