Anti-scan feature, Unlocking and locking the doors, 82 locks – FORD 2013 Explorer v.2 User Manual
Page 82
Anti-Scan Feature
The keypad will go into an anti-scan mode if the wrong code has been
entered seven times (35 consecutive button presses). This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity
• pressing the unlock button on the remote control
• the ignition is turned on
• unlocking the vehicle using intelligent access (if equipped)
Unlocking and Locking the Doors
To unlock the driver’s door: enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate. Note: All doors will unlock if
the two-stage unlocking feature is disabled. Refer to Locking and
Unlocking earlier in this chapter.
To unlock all doors: enter the factory set code or your personal code,
then press the 3
•4 control within five seconds.
To lock all doors: press and hold 7
•8 and 9•0 at the same time (with
the driver’s door closed). You do not need to enter the keypad code first.
82
Locks
2013 Explorer (exp)
Owners Guide gf, 2nd Printing
USA (fus)