Glove compartment – BMW M6 Coupe 2006 User Manual
Page 93
91
The corresponding memory button
1 is now
programmed with the signal of the original
hand-held transmitter.
You can operate the system when the engine is
running or when the ignition is switched on.
If the device can not be used after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button
1 of the integrated universal remote
control. If the LED
2 on the integrated universal
remote control flashes rapidly for a short time
and then remains lit for approx. 2 seconds, this
indicates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons
1 as described at Alternating-code
transmitters.
<
Alternating-code hand-held
transmitters
To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:
Programming will be easier with the aid of
a second person.
<
1.
Park your vehicle within the range of the
remote-controlled equipment.
2.
Program the integrated universal remote
control as described above in Fixed-code
hand-held transmitters.
3.
Locate the button on the receiver of the
device to be set, e.g. on the drive unit.
4.
Press the button on the receiver of the
equipment to be set. After step 4, you have
approx. 30 seconds for step 5.
5.
Press the programmed memory button
1
of the integrated universal remote control
three times.
The corresponding memory button
1 is now
programmed with the signal of the original
hand-held transmitter.
If you have any additional questions,
please contact your BMW center.
<
Deleting stored programs
Press both outer buttons
1 for approx. 20 sec-
onds, maintaining pressure until the LED
2
starts to flash: all stored programs are deleted.
Programs cannot be deleted individually.
Glove compartment
Opening
Press the button. The glove compartment
opens automatically and the lamps come on.
To prevent injury in the event of an acci-
dent while the vehicle is being driven,
close the glove compartment immediately after
use.
<
Closing
Fold the cover up.
Rechargeable flashlight*
The flashlight is located on the left side of the
glove compartment.
The flashlight can remain there continuously.
Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG