BMW M6 Coupe 2006 - Manual (Page 185)

M
o
bi
lity
183
Re
fe
re
n
c
e
At
a
g
la
n
c
e
Co
n
tr
o
ls
D
riv
in
g ti
ps
C
o
m
m
uni
ca
ti
o
n
s
Na
v
iga
ti
on
En
te
rt
a
in
m
e
n
t
procedures with correspondingly trained per-
sonnel. Due to the high voltage involved, there
is a danger to life and limb when work is carried
out improperly.
<
High beams, parking lamps
The illustration shows the front left side of the
engine compartment.
High beams
Bulb 55 watts, H 7
1. Remove the cover cap 1 by pressing the tab
and removing the cover cap upward.
2. Press the bulb holder from above to release
it.
3. Remove the bulb holder.
4. Remove and replace the bulb.
The lamp H7 is pressurized; wear eye
protection and protective gloves. Other-
wise there is a danger of injuries if the bulb is
accidentally damaged during replacement.
<
Parking lamps
Bulb 10 watts
Bulb holder and reflector are one unit and
are replaced together.
<
1. Turn the bulb holder 2 to the right and
remove.
2. Press the snap connection on the plug con-
nector, pull off the bulb holder and replace.
Front turn signal, side marker
Your BMW is equipped with two turn signal
lamps per side in the front.
Turn signal lamp 1
Bulb 21 watts, WY 21 SV
The illustration shows the front right side of the
engine compartment.
1. Press the lever shown:
> downward for the right turn signal
> upward for the left turn signal
2. Remove the bulb holder towards the rear.
3. Remove and replace the bulb.
Turn signal lamp 2
Bulb 21 watts, WY 21 SV
The bulb for the turn signal lamp 2 can be
replaced via the wheel well.
The illustration shows the front left side of the
vehicle.
1. Steering turned all the way to the left or
right.
2. Turn off the light, switch off the ignition and
remove the remote control from the ignition
lock.
3. Unscrew the bolt 1 with the open-ended
wrench from the onboard toolkit, refer to
page
182 .
Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG