Practical interior accessories, Integrated universal remote control, Practical interi or acc ess orie s – BMW M6 Coupe 2006 User Manual

Page 92

Practical interi

acc

ess

orie

Practical interior accessories

Integrated universal remote

control*

The concept

The integrated universal remote control
replaces up to three different hand-held trans-
mitters for various items of radio-controlled
equipment such as door openers and house
alarm systems. The integrated universal remote
control registers and stores signals from the
original hand-held transmitters.
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons

1. Then with the ignition switched

on, this programmed memory button 1 can be
used to operate the respective feature. The
LED

2 flashes to confirm transmission of the

signal.
If you sell your vehicle one day, delete the saved
programs beforehand for your own security,
refer to page

To prevent possible damage or injury,
before programming or using the inte-

grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the travel
range of the device. Also, comply with the
safety precautions of the original hand-held
transmitter.

Checking compatibility

If you see this symbol on the packaging
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to

assume that it is compatible with the integrated
universal remote control.

If you have additional questions, please
contact your BMW center or call:

1-800-355-3515.
Information is also provided on the Internet at:
www.bmwusa.com or
www.homelink.com.

HomeLink is a registered trademark of
Johnson Controls, Inc.

Programming

1 Memory buttons
2 LED

Fixed-code hand-held transmitters

Switch on ignition, refer to page

When using for the first time: press both
outer memory buttons

1 for approx. 20 sec-

onds until the LED

2 flashes. all stored pro-

grams are deleted.

Hold the original hand-held transmitter at a
distance of approx. 2 in/5 cm to 8 in/20 cm
from the memory buttons

The required distance between the
hand-held transmitter and the mem-

ory buttons

1 depends on the particular

system of the original hand-held transmitter
used.

Simultaneously press the transmit key on
the original hand-held transmitter and the
desired memory button

1 on the integrated

universal remote control. The LED

2 flashes

slowly at first. As soon as the LED

2 flashes

rapidly, release both buttons. If the LED

does not flash rapidly after approx. 15 sec-
onds, alter the distance.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.